Sometimes when you are trying to stream data from a 6 or 9-DOF shimmer, you might get only one data (i.e accelerometer data only). This might caused by the previous usage where you only enable a specific sensor instead of all available sensors in the Shimmer.
To enable it again, use Multi Shimmer Sync and enable all available sensors you want. Connect (and 'Start' to ensure it's really being enabled). After disconnect, try again on the 9DOF calibration software and check if all sensors are enabled.
Notes:
- Resetting the Shimmer doesn't seem to work... Not sure why.
:)
To enable it again, use Multi Shimmer Sync and enable all available sensors you want. Connect (and 'Start' to ensure it's really being enabled). After disconnect, try again on the 9DOF calibration software and check if all sensors are enabled.
Notes:
- Resetting the Shimmer doesn't seem to work... Not sure why.
:)
No comments:
Post a Comment